Equipment Xchange LLC
Buying & Selling Surplus Equipment Since 2000
HomeRecently AcquiredStainless Steel TanksRequest A Quote


309 Columbia Road
Hammonton NJ 08037

Phone 609 561 0500
Email [email protected]

...........................................................................................................................................................................
Used 16 quart Patterson Kelly twin shell blender with pin bar. Stainless steel. Approximatley 7" diameter X 13" conical section. Bottom outlet 3" oval. Includes covers, stand and two drives. SN LB 2651.
Item 11146-007 ​
Twin Shell Blenders
Used approximately 20 Cuft Patterson Kelly twin shell blender. Rated 65 #/cuft. Stainless steel shell. Painted exterior. Standard solid discharge port covers. With stainless steel intensifier bar driven by 1.5 hp 3/60/208-220-440v motor. Main drive is a 2 hp 3/60/230-460v motor. With gear reducer. On stand with extensions.
Item 11458-001  

Used Patterson Kelley stainless steel twin shell blender 16 quart. 1/15 hp bar drive (requires bar) 3/4 hp main drive.  
Item 11670-004  

Used Gemco approximately 30 Cuft T304 stainless steel "V" Blender. Rated 100#/cuft. With 5hp drive. On stand.

Item 12016-001
Company
Contact
Email
Phone

Address

Requirements

USED approximately 10 cubic foot working capacity stainless steel twin shell blender. Has 2 hp, 3 phase, 60 cycle, 208-220-440 volt, 1745 rpm gearhead motor. Maximum material density 135#/cubic foot. A-Frame supports. Built by Patterson Kelly.  
Item 11350-002  
Used Patterson Kelley twin shell blender approximately 50 cubic foot working capacity, 83 cubic foot total capacity. Stainless steel mixer contacts with stands and leg extensions. Shell diameter 42". 5 Hp Motor 3/60/208-220-440V with reducer - approximately 14 rpm blender speed. Includes covers, leg extensions and guards. Bottom outlet with valve. 
Item 12970-001
Used approximately 10 cubic foot, Patterson-Kelley, Twin Shell, V-Blender with Intensifier Bar. Shell is T304 Stainless Steel and the frame is made of Carbon Steel. The intensifier bar spins at 1325 RPM and the shell spins at 14.7 RPM. The maximum density of the material it can handle is 150 lbs/ft3. 3 H.P., Totally Enclosed, 3-Phase, 60 cycle, 220/440 volts, 100 RPM, Elliot Gear Motor, Frame #254-322 with a motor-mounted, magnetic brake which runs the shell. There is a 3 H.P., Totally Enclosed, 3-Phase, 60 cycle, 220/440 volts, 1750 RPM, Elliot Motor, Frame #213 which runs the intensifier bar. 
13019-001