Equipment Xchange, LLC  

Home | Click Here to Contact Equipment Xchange

Phone: 856-661-9393

Fax: 856-661-9338

 sales@exllc.com

 

Surplus Process Machinery & Equipment   

 

Cleaver Brooks Packaged Fire Tube Boiler, model CB600-750.  Was originally constructed in 1986 in strict accordance with the ASME Code for a design pressure of 150 PSIG. #6 Oil The unit is a four-pass dry back design with 3500 square feet of fireside heating surface. The shell is insulated with two inches of compressed fiberglass and covered with a heavy gauge sheet steel casing. The fully modulating forced draft burner is integrally mounted, piped and wired on the boiler front allowing for ease of flame observation, set-up and maintenance.  Valve trim, controls and auxiliary equipment include;

-Primary low water cut-off; McD&M No. 157-A
-Secondary low water cut-off; McD&M No. 150M
-Boiler valve trim including; Feed water stop and check valves, blow down valves (3), surface blow-off valve, vent valve and safety valves per ASME code
-Water column with sight glass, gauge cocks, tricocks and blow down valves mounted on the primary low water cut-off.
-Front and rear hinged covers
-Pressure gauge and stack thermometer
-Boiler/Burner control center consisting of the primary flame control and detector, motor starters, relays, fuse blocks, limit switches, alarm bell, indicating lights, control circuit transformer, low fire hold control and manual potentiometer with selector switch
-Steam pressure limit switches; operating limit, safety limit with manual reset, modulating steam pressure controller and low fire hold control
-Atomizing air compressor with lube oil tank and cooler
-Fuel pump and drive, shipped loose
-NEMA1electrical entrance box and control panel
-Rigid and seal-tite conduit and wiring
-NFPA-8501 safety code requirements
-IRI and FM insurance approvals, U.L. Labeling

Connections: Dimensions:

-Steam - 8" x 300# Length, overall - 25’ 00”
-Blow down - 2.0" NPT shell - 19’ 05”
-Blow-off - 1.0" NPT Width, overall - 10’ 03”
-Oil, S&R - 1.5" NPT shell - 9’ 06”
-Feed water - 2.0" NPT Height, overall - 11’ 02”
-Nat. Gas - Not Applicable exhaust - 10’ 06”
-Exhaust - 24" ID Weight, shipping - 54,000 Lbs
-Electric - 460v/3ph/60cy operating - 76,000 Lbs

This unit is offered fully reconditioned, shop tested and factory painted with a one-year parts warranty, subject to prior sale or rental.

Item 11169-002

No photo available.

Contact Equipment Xchange today for all of your machinery needs!

 

 

 

 

Equipment Xchange LLC

9105 Burrough Dover Lane Pennsauken NJ 08110

James Duke - Jack Anthony DeStefano - Don Alf

Jim "Ricci" Ricchini - Scott Tarzy - Kristina Smylie